Pagina 1 di 1
Controllpanel flashing red lights
Inviato: 10/03/2025, 23:28
da Cpt_keen79
Hello, I've had a problem with the control panel since yesterday. The two red LEDs are flashing and I no longer have any power for the lights and water pump. I can't switch on any devices using the 220 V connection either. According to the measurement, the battery still has 14.7 volts. What could be the cause of the problem?
[img]
[img]
[img][b][/b][/img][/img][/img]
Re: Controllpanel flashing red lights
Inviato: 11/03/2025, 18:49
da SimoneR
Hello
You have a comunication problem. The problem caused by one (or all two boards) or on a cable. We suggest to go to a dealer to check the system.
Re: Controllpanel flashing red lights
Inviato: 12/03/2025, 9:15
da Cpt_keen79
Thanks for the reply. I was at the dealer yesterday and they checked the cable connections. They also installed a new battery. The circuit boards on the panel and in the EBL look fine. Perhaps there's still a problem with the relays? 14V is coming through to the panel. Do you know a dealer in Germany who can check and repair the circuit boards? Or can I still buy new ones? Thank you for your help.
Re: Controllpanel flashing red lights
Inviato: 13/03/2025, 0:38
da SimoneR
Hello. Probably the problem is on one or all electronic boards. Check on roller team website where is a dealer to check the system. Normally the dealer have the part to change on your motorhome to find e where is the problem.
Re: Controllpanel flashing red lights
Inviato: 18/03/2025, 17:05
da Cpt_keen79
I've now tried to find the problem myself again to save money. What I've discovered is that the refrigerator doesn't switch to 12V when the motor is running. When I switch it manually, the battery symbol and a wrench flash. I think the D+ signal is missing. Which relay or component could be causing this?
Re: Controllpanel flashing red lights
Inviato: 18/03/2025, 21:53
da SimoneR
Hello
The fridge is connect on fuse board. You need to check if you have the input signal on our board when engine run.