Information panel

[Patrik]

Hey!

I have a Rimor Sky Free, 2016. After three months of use, the information panel has stopped working. None of the connected sensors respond. The pump does not work. I can start the panel but not anything else. The lights work, but they are switched on in new places in the car. Panelel is an LcdTTK.6318. All the fuses are ok.



What can I do to make it work again.



With kind regards



Patrik Brandby

[SimoneR]

Hello. Check on pump node (near water tank) if the led is ON and if it flash or is always ON.

[Patrik]

Hello!



I have a green diode that flashes red every 2 seconds.



// Patrik

[SimoneR]

Hello. Try to disconnect pump node and check if all leds on other board (like a powerlink) flash only green. If all leds flash green, the problem is on pump node.

[Patrik]

Hello again!



When I pulled out the pump plug, the control diode started flashing green. The information panel received information about battery status and the lights worked again.



Is the pump broken, must it be replaced?



Regards



Patrik

[SimoneR]

Hello



To solve the problem you must change the pump node and install a diode to protect the node by overvoltage.

Please write me an email (Assistenza.tecnica@arsilicii.com) with a photo of the node and I write you all info to buy it.

[Patrik]

Thank you for a good service and nice response.



I am impressed that this service could be done over the weekend.



Many thanks.



Best regards



Patrik Brandby